Cart
French English
 
 
 
 
 
 
  Categories
     Home     Informations     Catalog     Partners     Contact    My Account     
  Wind turbines
  Solar Modules
  Solar Systems
  Wind Solar Systems
  Charge Controllers
  Inverters
  Solar Batteries
  Solar Air Conditioner
  Hydro generator
  Solar Heating System
  System Monitoring & Meters
  Solar Hot Water
  Solar Lighting System
  Solar Pool System
  Wind Solar Lighting System
  Solar Pumping System
  Wind Pumping System
  Wind Solar pumping System
  Back Up System
  Energy Efficient Products
  Trackers
  Solar Accessories
    Communications
    Lightning Arrestor
    Mounting
    Active voltage level
    Cables
    Generator Starter
    Adjustable Desulphator
    Voltage Converter
    PowerTransfert
    Automatic transfert
    24 V From 12V Power source
    Combiner box
    12 V From 24V Power source
    Coffret FlexPowerOne
    Grounding
    DC Breakers
    MC Connector Cables
    Remote temp Sensor
    Solar Anti-Mostiquo
   
DGS1Ac Generator Starter
[DGS1AC]
477 $CA

Basic Operation

This Genset starter monitors the battery voltage, and when the battery voltage gets too its low setpoint, the unit starts the generator. When the battery gets to its high setpoint, the unit stops the generator. The generator may be remotely started and stopped by dry contact closures, or by its local toggle switch start stop commands. The setpoints may be temperature compensated with an optional remote temperature sensor.

Available in Model (GS-1AC) optimized for starting AC generators or Model (GS-1DC) for DC generators. This product is available in an enclosure or open frame design for mount in your own enclosure.

Features

  • Single unit 12 V up to 48 V battery systems
  • LEDs indicate relay positions and generator status
  • Temperature compensation (-4 mv / deg C./ cell) on start and stop voltages with optional temperature sensor TC-2
  • remote start and stop controls as well as local start/stop control
  • 5 second retirggerable time delay on voltage sensing to prevent false starts/stops
  • Supports 2, 3 and 4 wire systems as well as advanced control systems
  • Low Cost/ High Reliability

Electrical Specifications

  • Base Model: GS-1
  • Nominal battery voltages 12 - 48 V DC
  • Maximum Input (V) 63
  • Minimum Voltage 10
  • Relay: 8 amps @ 12/24 V , 2 amp @ 48 V , 5 amps @ 120 VAC rating of Potter and Brumfield T72 series relay
  • Self Consumption (A)
  • Relay Power: 0.5W per relay coil when powered, voltage independent
  • Quiescent less than 20 mA,Fusing 1 A, internal electronics only

Sequence of Operation on Startup

When the battery voltage is detected as too low per user adjustable setpoint the generator goes through its start sequence.

1.     The Generator start LED comes on.

2.     Precrank: 20 seconds relay closure (with LED on) prior to generator start/crank.

3.     Crank: relay closure (with LED on) for 10 seconds or until Genset start detected defined by generator/battery voltage starting to rise.

4.     Run: Relay closure (with LED on) whenever generator is cranking or running.

5.     Load: load relay closure (with LED on) for 30 seconds after run relay closure.

6.     If battery voltage falls another 0.2 V (relative to 12 V battery), fault relay is activated for remote signaling of fault.

 

Shipping:

 

5550 W  Wind Solar Tilting System
5550 W Wind Solar Tilting System
33,941 $CA
32,560 $CA